<aside> ⚠️ The required strength for fixing to the structural wall is 27kg

</aside>

CTOUCH Wallom3 wall lift is used to mount a large touchscreen or monitor indoors in place. The lift function ensures that the viewing height is adjusted to the user. The lift should be used for a maximum of 1 min. at a time, followed by 19 min. rest, regardless of the load. Ignoring these instructions will dramatically reduce the system’s lifecycle.

Usable with

VESA SIZES

• 400 x 400mm
• 600 x 400mm
• 800 x 400mm
• 800 x 600mm

Not included:

At least 4x wall screws for your type of wall, capable of holding 27kg of weight.

Components:

Lift

WA: Frame with electric lift

WB1: Wall mounting (wall)

WB2: Wall mounting (front)

WC: Front panel

Cables & accessories

WD: Motor cable

WE1: Button control

WE2: Button control cable

WF: Power cable

WG: Control Unit

Mounting

WH: VESA Bracket arms

WJ: Support arms

WK: Lock & 2 keys

Screws & bolts

1. 1x Wrench
2. 1x Allen key

Screen mounting 3. 12x M8 washers 4. 4x 25mm standoffs 5. 4x M8 X 30mm (for WJ: Support arms) 6. 4x M8 x 20mm bolts (for WH: VESA Brackets) 7. 4x M8 x 12mm bolts (for WH: VESA Brackets)

Remote mounting 8. 2x Small screws for lift control remote. 9. 1x bracket for lift control remote mounting

<aside> ℹ️ Changes or modifications will void all warranties and exclude any liability. This user manual contains detailed instructions about your product. Pictures and illustrations in this manual are for reference only and may differ from the reality. Design and specifications are subject to change without notice.

</aside>

1. Mark the height of the lift’s backplate

Remove the frame with electric lift (WA) from the box , and place it against the wall in the way you would like it to be mounted. Use a pencil to mark the location of the top of the back wall mounting plate (WB1).

2. Mark the mounting holes of the mounting plate (WB1) on the structural wall

Unscrew the bolts holding the two wall mounting plates together (WB1 & WB2) using the wrench (a) and Allen-key (b). Then place the back wall mounting plate (WB1) against your first marking lines. Mark at least 4 drill holes in the slots running down the center of the back wall mounting plate (WB1). Erase your first line for a clean result.

3. Attach the wall mounting plate (WB1)

Lower the mounting plate (WB1) from the wall and drill at least four of your marked holes in the structural wall. Attach the wall mounting plate (WB1) to wall using appropriate screws. Mount to the wall using screws that can hold at least 27kg of weight. When fastening, ensure that the 4 small screw holes are at the top (marked with an arrow in the drawing).

4. Install the supporting arms