The CTOUCH Wallom3 mobile lift system is a solution for the use of large screens in different indoor locations. The lift function ensures that the viewing height is adjusted to the user. The lift should be used for a maximum of 1 min. at a time, followed by 19 min. rest, regardless of the load. Ignoring these instructions will dramatically reduce the system’s lifecycle.

Usable with

VESA SIZES

• 400 x 400mm
• 600 x 400mm
• 800 x 400mm
• 800 x 600mm

Components:

Lift

WA. Top frame with electric lift

WB. Base frame with wheels

WC. Front panel

Cables & accessories

WD. Motor cable

WE1: Button control

WE2: Button control cable

WF. Power cable

WG. Cable container with Control Unit inside

Mounting

WH. VESA Bracket arms

WJ. Support arms

WK: Lock & 2 keys

Screws & bolts

1. 1x Wrench
2. 1x Allen key

Frame mounting 3. 4x M8x80 bolts (for base frame) 4. 4x M8 Washers (black) 5. 4x M8 spring-washers 6. 4x M8 Nuts 7. 4x M8 Nut covers (black)

Screen mounting 8. 8x M8 washers 9. 4x M8 x 30mm bolts (for WK: Support arms) 10. 4x M8 x 20mm bolts (for WJ: VESA Brackets) 11. 4x 25mm standoffs

Button mounting 12. 2x Small screws for for lift control remote. 13. 1x bracket for button control box

<aside> ℹ️ Changes or modifications will void all warranties and exclude any liability. This user manual contains detailed instructions about your product. Pictures and illustrations in this manual are for reference only and may differ from the reality. Design and specifications are subject to change without notice.

</aside>

1. Mount the base frame (WB) on the top frame (WA)

Keep the longest arms of the base frame (WB) at the front of the lift's top frame (WA) during assembly. The front of the top frame (WA) has bolt holes near the top.

When installing, position the upper frame (WA) horizontally on its own packaging material (see figure below) to prevent damage whilst aligning the holes.

Bolt the base (WB) onto the top frame (WA) by threading 4x M8x80mm bolts (c) with M8 washers (black) (d) through the bottom of the base (WB), and fastening them with 4x M8 spring-washers (e), and 4x M8 Nuts (f). Ensure the bolts are fastened securely. Lastly, cover the bolts on the top with the M8 Black nut covers(g).

2. Attach the front plate (WC)

Wipe the front of the lift thoroughly with a sanitary wipe to remove any oils. Set the system upright and fasten the front plate (WC) to the lift column (WB) using the tape of the Velcro strips inside the front plate (WC).

3. Install the supporting arms

Slide the support arms (WJ) through the upper frame (WA) and secure with 4x M8 Washers (h) and 4x M8x30mm nuts (i).

4. Install all cables WD, WE2, and WF