This is something I wish existed somewhere because it was very unclear what the standard workflow was supposed to be. So hopefully this will save someone some time.

Primary Workflow

This workflow assumes you've built a frame and the Maslow already and updated the firmware:

1. Retract all cables
2. Extend all cables
3. Mount Maslow to frame
4. Calibrate the machine
5. Set Z-stop
6. Release tension
7. Unmount Maslow from frame
8. Retract all cables
9. Mount work piece
10. Extend all cables
11. Mount Maslow to frame
12. Apply tension
13. Raise Z height for bit clearance
14. Load router bit
15. Set Z home (different than Z-stop) - Lower the Z height until the bit just touches the work piece, back off 1 mm, then hit the set home button
16. Load G-code file
17. Select G-code from dropdown