BACK TO NAV MENU →Simple Synth Manual

Initial front panel presented at Superbooth 2022. Transparent plexiglass. Sampler by Roberto Noris on the Daisy Seed Microcontroller.

Initial front panel presented at Superbooth 2022. Transparent plexiglass. Sampler by Roberto Noris on the Daisy Seed Microcontroller.

Table of contents

Preparing the board - Daisy Seed

Below is a diagram showing the basic Simple x Daisy Seed microcontroller setup. Three wires should be connected:

<aside> 💡 If you’re new to soldering check out the Soldering basics page for video tutorials. Soldering isn’t hard, but you do need to follow some best practices to do it right.

</aside>

<aside> ‼️ note that if you put your Daisy on the flip side of the Simple board, your pins are flipped, so no.01 is no.48

</aside>