Universal Laser tool use notes:

<aside> ⚠️

The tube is about done for. This laser is being replaced soon.

</aside>

The only recommended SETTINGS are: Flow = ON {check mark} Flow rate = 100% {slider}
The laser is occasionally run with out any are flow { Flow = OFF; Air Flow Rate = 0% } this will cause cutting debris to clog the air nozzle located closest to the cut.
If the laser is run with a low flow rate { Flow = air on ; Air Flow Rate < 50% } the machine will trigger a “ Air pressure too low “ Error. It seems the sensor in the head is unable to register the flow rate, likely due to the fish pump giving the machine ~7 psi and the machine needs 50 to run as intended.
It is plausible that the fish pump puts some debris and oil into the air system and increases the chance of a clog in the lines before the cutter. An “ Air pressure too low “ Error has been seen before under presumably normal settings, and was fixed after disassembling the laser cutting head and associated air lines coming from the rear left.

Approved Materials:

Currently only Acrylic, Paper/Cardstock, Cardboard, and Wood is approved without question.
For all other materials please contact us and get approval before cutting