When cleaning the swimmers, the head of the equipment comes up?

Solution: Clean the filter net. If the filter net is blocked, it will cause the suction power of the device to drop, which will in turn cause the head of the device to rise.

What is the difference between the actual operation time and the transmission time of the equipment?

Solution: The operating times listed in the handbook are measured under the test conditions. In the actual pond, the operating environment and cleanliness can be shortened or extended by up to 20%.

What if the equipment operator floats away from the raised wall after cleaning the waterline under a raised wall scrubbing system?

Solution: Prolonged cleaning of the water line causes excessive air intake into the bottom panel, causing the equipment operator to pinch the raised wall during the descent process. The following is a list of the most common problems with the water line cleanliness.

What if the equipment operator is not able to crawl back up to the raised wall under the raised wall cleaning system?

The solution: 1. You can manually clean the wall first, then re-use the equipment to clean it more deeply. The filter baskets and brushes will affect the cleaning ability of your equipment. Please check the basket and brushes for cleanliness. Check the environment of the pond for problems, such as: the pond bottom having sharp-edged horizontal surfaces, excessive exposure to pings due to unobservable pinging, or low friction of the pond material, which can lead to an excessive slipping of the pond wall, which can cause the equipment to creep up on the pond wall.

What type of equipment railing is needed to reach the water level line?

Solution: This can be caused by environmental factors, such as excessive pollution on the surface of the pond or low friction of the pond material, leading to the pond wall slipping too heavily. Certain areas of irregularly shaped swimming pools (such as corner drops, bends, etc.) can reach the water level line without any problem. If the problem is caused by excessive pollution, manually clean the swimming pool first, and then use the equipment again to clean it at depth.

Will the equipment continue to turn over after opening?

Solution: The initialization of the IMU model with anomalies creates a misinterpretation of the nanocrystal. The power supply is connected and closed, and the machine is working normally again.

What if the equipment is not moving in the water?

Solution: Water quality is not good, so increase the density of the water - make the water more relatively dry. If too many bubbles are on the outer shell of the equipment after the water is added, it is possible that the equipment will stop working. After the water is injected, let the water settle for a period of time, and then re-install the equipment.

What if the equipment has a leaking cleaning area, insufficient cover, or less than ideal cleaning results?

Solution: If the surface material of the pond wall is not the same, a surface with low friction force will lead to the same area being cleaned (reduced weekly coverage), while a surface with high friction force will lead to leaking clean spots or difficulty cleaning when the pond area is relatively large. When the surface of the water reservoir area is relatively large, it will be difficult to clean. Installation maintenance: prolonged use or immobility will affect its effectiveness. Key components for regular maintenance and upkeep, such as a rolling brush, a belt, and a filter basket, ensure optimal operation.

What if the equipment is not kept clean in the repose area under the pond bottom cleaning system?

Solution: The angle of creepage of the equipment should be 20 degrees. Exceeding this angle will cause the equipment to crawl without any problem. When these areas are being cleaned, the equipment must be moved manually.

Are there any water droplets or stains on the newly purchased equipment?

If you have any questions, please contact us. Please be assured that this is a normal manufacturing process and our products have a perfect quality assurance and you will never have to worry about it again.