I started by taking apart the plush frog. I was hoping that the eyes would be hollow so that I could drill holes for the OpenMV cam and the speaker but that was not the case.
Since the eyes were not what I expected, I played with sewing the speaker to the outside of the frog's eye
For the camera, I decided to use a grommet to finish the hole. I did end of doing this for both eyes in the end (See later photos for more info).
Grouped + and - leads of the motors together.
Soldered the leads onto one shape terminal each to be connected to the Raspberry Pi.
Used heat shrink around the anode and cathode of the LED.
Added header pins to the wires for connecting into the OpenMV with the hopes of a more secure connection than just the bare wire. This proved to be an incorrect assumption.
Had to cover the spade connectors with wire tape.
I used an old gift bag to stuff the original stuffing into something more secure before returning to the body.