In this Section
Digikey, Mouser, and LCSC are all good places to put together component carts.
[ ] Use the Interactive Bill of Materials to aid in placing parts during assembly.
[ ] Typical assembly uses solder paste and a reflow oven. Nevertheless, everything but the IMU can be soldered by hand! 🖐
See my introduction to soldering tutorial to brush up on your soldering skills 👇
[ ] After assembly, the board should be powered via the USB port and a multimeter used to verify a 3.3V voltage is read between 3V3
and GND
.
<aside> 👉 If you're unable to read 3.3V, see: Troubleshooting
</aside>