Status

• After a first print, the ramp definitely has issues
  • Its walls are too thin;
  • The tolerances are too tight;
  • The bottom should have less contact surface;
• v3.2 = Lower Body is shorter
• v3.1 = Adjustable with ramp with a multitude of corrections and ready for print - link
• v3 = Initial concept of the adjustable ramp with levels from 20mm to ~40mm;
• v1.1 = Round instead of straight top - link
• v1 = Small updates after testing 1st print see - link

Requirements

• Easy to produce
• Adjustable height
• Modular to combine with more
• Lowest setting requires no accessories
• Highest setting is sturdy
• Bottom has ridges to put rubber/dry glue

Ideas

• Top and bottom body
• Mounted on an axis
• Accessories
  • Simple rod to place in slots
  • Simple board to support on highest setting
  • Rubber band to hold tightly closed

Prints

Concept by 3rd party